DIY Bracelet Shoelace Crafts APK

DIY Bracelet Shoelace Crafts

Hundreds of Bracelet Shoelace Crafts Ideas for you - Bracelets can be made of any material, from gold, plastic or iron mix. What's more trendy nih simple-simple example of a bracelet from a rope.Try lo see the young people now on average make bracelet from tali.Trus how to make it?

Tools and materials :
• Scissor
• Prushut straps (Alternative wearing scout straps)
• Matches

How to make:
• Cut the rope to a total length of 2 Meters (1 Meter white strap, 1 meter orange rope) after cutting off a little rope end

Then take another rope that will be used as the main rope, then measure in hand that will wear it. The result of the measure multiplied by 3, for example: the measurement result is 18 cm so you have to cut up to 54 cm

• After the cut back burn both ends then paste until it becomes one unity

• After in tarulah tarulah rope as in the picture below. And the placement distance is approximately 1/3 the length of the main rope from the tip. Then put one side of the rope, above the other rope like in the picture below.

• then pull the rope through the bottom and insert the piercing that has been made, as in the picture below. Then rehearse

• After being stretched, take a white-colored rope and make a curve to the side, then paste under the orange rope

• Then insert the red string into the hole made by the white string that was like in step 6 then hard

• Perform the steps (steps 7 and 8) continuously up to 1/3 of the length of the main rope.

• After the length of the bond has reached 1/3 of the main rope cut the rest of the bond strap.

• The results of the pieces we connect back by way of burned ends and in the paste so that it becomes one more string.

• Align both ends of the main rope Then tie the two straps (do steps 4-6) like the picture below. Do not be too tight because in this part of the key of this bracelet.

• do step 7 and 8 repeatedly and according to hand size do not bind too hard because it can make the bracelet difficult to open.

• Once enough cut the rest of the rope out of the bond. And the rest burn a little and then paste in order not easily loose.

• then at the end of the main rope tie and cut a little to make it look neater.

• Finish bracelet made andah itself has been completed.

To find other ideas to make Bracelet Shoelace Crafts you can find in this App, which is available over hundred DIY Bracelet Shoelace Crafts that are easy to make, beautiful and definitely you will love.

Good luck