Desain Lampu Langit Langit APK

Aplikasi paling popule

ceiling lighting in the room at this time is not limited to one or even chandeliers with lampshade, today offers a variety of lighting options, which can be as basic or tambahan.Banyak ceiling lights mounted on their own, and below we will see how to set diode lighting from the ceiling with his hands before mounting tension ceiling.

LED Strip

  The most often used to assist illuminator LED ribbon, but this device is not the same, so you definitely need to understand what merekaPerbedaan.Untuk do this, the following table describing the recording on the number of diodes on the 1st and power:
type LED number: 3028 SMD, diodes in one meter: 60, Power 1m / W: 4.8
type LED number: 3028 SMD, diodes in one meter: 120, Power 1m / W: 7.2
type LED number: 5050 SMD, diodes in one meter: 30, Power 1m / W: 7.2
type LED number: 5050 SMD, diodes in one meter: 60, Power 1m / W: 14

Brightness recording density is determined by a
know the number of diodes per meter track lighting .Also, the tape may be a different color, that is, perhaps, white and red, yellow, green and biru.Ada also multi-color RGB recording with the ability to change color.

Do LED strips there is a degree of protection against kelembaban.Untuk devices that have this protection, is a symbol of IP, is sometimes added to their number.
What is needed for installation Rope
For full installation of the tape, this is a diode lamp ceiling must be accurately cut to length .On the location of any cut is always present, sometimes even in the form of small scissors, and if you cut right, you see the contacts of each channel.
to connect the LED strips can be used connectors, but here's the problem - is not always possible to do this because of the quality of all components of society miskin.Dalam such a case, they can only weld, but it is very important that the wire that produces welding, channel resistance ribbon equal and in this case can only use the cable from the connector can not be used.

  For the selection of the power supply must know the voltage and power, to match the length of the tape which is connected itu.Misalnya, when power 12V, the meter LED strip with 120 diodes is 7,2Vt, then you will need 10m 10 × 7.2 = 72Vt.Tapi should consider the safety factor, and it is 1.25, thus 72 × 1,25 = 90W - it will be required power supply unit.
  Another factor that determines when selecting a power supply for a ceiling of diode-backlit will iklim.Misalnya room, if the room has a surplus of moisture (kitchen, bathroom), you'll need to block for wet rooms
  If you buy a colorful ribbon, then you need a color management controller, in addition, you can adjust the brightness and light, but this is only if you add dimmer.Di white LED strip (Rope), you do not need to be equipped with a color controller.Controller remote control and mode (Rope may not only color, but walking).
  Rope connections for up to 12m consistently held, and more than that - a parallel, but nonetheless, it's better to specify when buying the tape, which may change zavodom0 manufacturers.
for mounting diodes sticky side of the tape provided, such as double-sided tape .You simply remove the protective film and stick Rope to the ceiling (see. Installing LED lighting in the ceiling, the optimal solution) .Permukaan the tape glued to be pre-treated with a primer to adhesi.Jika allows you kleite recording in drywall, primed surface is not enough need to just remove the dust that accumulates in refurbishing the place.
rekomendasi.Ketika connect LED strips and components required to match the polarity, because the error will cause fatigue Rope! When mounting tape on a metal surface is always necessary isolation!